Switch to the Sequoia Standalone mode

Switch to the Sequoia Standalone mode

Problem/Question
In case the communication to the Master workstation does not longer work, the Ergosoft standalone configuration can be used to make a workstation run independently.
“How can i switch to the Standalone mode"

Solution/Work-Around
Switch from Client in the Standalone mode
  1. Open the "ErgoSoft ControlCenter"
  2. Select the tab "Tools"
  3. Open <Maintenance Tool>
  4. Execute <RIP Master/Client configuration>
  5. Change from Master/Client to Standalone
Note: For the operation in standalone mode a separate dongle and a corresponding license is required

Related Articles & Links



    • Related Articles

    • Sequoia license information

      Problem/Question Where to get information about the currently existing licenses? Note: You may need this information to check which options are listed to update the license for e.g. additional PrintQueue on a Client. Solution/Work-Around You can ...
    • Sequoia Master PC is not found by the Client PC

      Problem/Question When starting a Client PC the you receive an error message that the Master PC cannot be found. Usually this is a communication problem between the master and the clients. Solution/Work-Around Exit the "Ergosoft ControlCenter" on ...
    • Sequoia Master PC crash

      Problem/Question The Sequoia Master PC is crashed or is temporarily not available. Solution/Work-Around Procedure using a new PC: Install the latest Version of Ergosoft Follow the Installation Description Note: be sure to have the same release ...
    • Networked Department Start order (Error messages when Client start)

      Problem/Question The following messages may appear when starting a Network Department Client: If this message does not disappear in seconds/minutes, the Client can't connect to the Master. (A permanent network connection between all Networked ...
    • Sequoia Modes

      Problem/Question When installing Sequoia you will be asked in which mode you want to install the software. This raises the question “What is the difference between the modes you can run Sequoia?" At this installation window you can select which ...