Connect Multiple Mimaki USB printers
Problem/Question
When connecting several Mimaki USB printers to one Ergosoft RIP PC, connection problems might come up and the question arises
“How do I set up multiple Mimaki USB Printers to run on the same PC?"
For stability and speed reasons, we recommend to only plug one USB printer each RIP PC. If there is a need for attaching two USB printers to one RIP PC, it is strongly recommended to not plug two printers into USB ports directly next to each other, adjacent ports often share the same power supply and voltage, which in most cases is not enough to ensure stable communication for two devices.
Solution/Work-Around
When setting up the ports for the individual printers,
we recommend the following procedure in order to avoid setting the same port
for multiple devices.- Install the USB driver the manufacturer is referring to on the website
- Switch off all Mimaki USB printers
- Delete all Mimaki USB ports (from the port configuration in the Print Environment, if already set up some)
- Shut down the Ergosoft ControlCenter
- Restart the Ergosoft ControlCenter
- Switch on Mimaki USB printer 1
- Create or select a existing Print Environment for Mimaki USB printer 1
- Configer the Print Port at "Output Device"
- Add the "Mimaki USB2 Port"
- Close the Print Environment
- Switch off Mimaki USB printer 1
- Switch on Mimaki USB printer 2
- Perform the steps 7. to 10. for Mimaki USB printer 2 and 3
Note: The Mimaki USB2 port has two or more selectable ports (depending on the number of printers connected) after correct setup. These are assigned to the individual Print Environments by the procedure.
Note: Even though we are talking about Mimaki in this article, the step-by-step instruction could also work for other brands.
Related Articles
USB Mimaki port cannot be opened
Problem/Question Printing is not possible, the Mimaki printer rejects the data when sending a job from the PrintQueue. The message above indicates, that the USB communication cannot be established properly. The communication between the PC and the ...Mimaki USB connectivity issues
Problem/Question RIP PC or Ergosoft gets no connection to the printer or data transfer stops in the middle of printing using a USB connected Mimaki printer. Solution/Work-Around Check the connection of the USB Cable Remove the USB cable at the end of ...Mimaki USB connectivity issues
"RIP computer and Machine can’t be connected, what should I do? " Problem When RIP Computer and PC cannot be connected well or data transfer stops in the middle of printing, please follow the below information and check if the problem persists. ...Use Epson USB port
Problem/Question How is an Epson USB Port added to the Print Environment? Since there is no Option for it when adding a new Port. Solution/Work-Around As Epson USB does not have its own interface between the Ergosoft RIP and printer, a Windows ...Mimaki – Parameter Error (PICT)
Problem/Question When sending a job to a Mimaki printer, the job is not printed and you get an error message on the printer display. The print settings and device options of the current Print Environment are not supported by the printer. This may be ...