Where do you rip in Sequoia?

Where do you rip in Sequoia?

Problem/Question
A fundamental question that is asked again and again:
“Where do you rip in Sequoia?"

This is important for the System Requirements to know.

Solution/Work-Around
In Sequoia, ripping is always performed on the Client on which the PrintQueue used is located.

Note: the PrintQueue is created by adding a Print Environment on a workstation that controls the printer / cutter.

Related Articles & Links

    • Related Articles

    • TrueShapeNesting on Networked Departments (Sequoia)

      Problem/Question On Networked Departments systems (formerly Sequoia), it is not possible to do TSN on the Client PCs. Solution/Work-Around Per Default, the TEMP folder on the Master (_Server\Files\TEMP) is set to store TSN generated PDF files. This ...

    • RIP Engines configuration

      Problem/Question No rip processes are performed. No RipEngine seems to be active. How to change the number of active RipEngines? At least one RipEngine is required to perform a rip process. Raster performance of the Ergosoft RipEngine mainly depends ...

    • Sequoia Master PC is not found by the Client PC

      Problem/Question When starting a Client PC the you receive an error message that the Master PC cannot be found. Usually this is a communication problem between the master and the clients. Solution/Work-Around Exit the "Ergosoft ControlCenter" on ...

    • Sequoia Limitations

      Problem/Question Ergosoft 16 Sequoia has some limitations that are important for installation and use. Solution/Work-Around Installation Master and all Sequoia workstations must use the same build version 64-bit and 32-bit installations in ...

    • Networked Department Start order (Waiting for Ergosoft communication)

      Problem/Question The following messages may appear when starting a Network Department Client. If this message does not disappear in seconds/minutes, the Client can't connect to the Master. (A permanent network connection between all Networked ...