How to configure the barcode position for flatbed cutters?

How to configure the barcode position for flatbed cutters?

Problem/Question
When printing barcodes for flatbed cut drivers the default position of the barcodes do not suit your needs, e.g. because you print the job centered for transfer sublimation and your paper is wider than the fabric so that the default barcode may not be transferred to the media.
You found the barcode configuration in the "Barcode" section of your cut environment and wonder how to use the square and round marks for the barcode position.

Solution/Work-Around
The barcode configuration allows setting the sides on which the barcode is printed as well as the position within the job width for the top and bottom barcodes.

Configuration of the side at which the barcode is printed:
The square boxes stand for the side of the printout. They can be combined.





Configuration of the barcode position within the top or bottom of the printout:
The round selections stand for the position within the top or bottom. Only one selection for "Top" and one selection for "Bottom" is possible.



(This printout is cheated for the explanation. It is not possible in reality.)

    • Related Articles

    • Mimaki CJV150 Cut Only

      Problem/Question Cut Only job is moved to the Done section after dispatch but the device is not moving - not cut has been done. Caused by the variety of different USB driver provided by Mimaki, somtimes cut only on the CJV150 does not work properly. ...

    • How to use Summa F-Series Cutters?

      Problem/Question How to use Summa F-Series Cutters? Solution/Work-Around To use the Summa F-Series Cutters, you should follow the normal Ergosoft procedure for cutting. It just need special attention regarding the Driver mode you want to use. Please, ...

    • Print & Cut Devices possible Cut driver selection

      Problem/Question For Print and Cut devices, usually up to 3 different Cut drivers (Cut after, Using Marks and Cut only) can be selected. Some of them are arranged "hidden". "Where can I find the individual Cut drivers and how to add them?" ...

    • Cut button grayed out / not available

      Problem/Question ContourCut is licensed, but the “Cut” button in the software is grayed out and cannot be used. Solution/Work-Around “Contour Cut” has to be activated Within JobComposer select "View" (top menu) Open "Tools" Check "Cut Environments" ...

    • Create Job Package

      Problem/Question In addition to archiving a job from a Queues, e.g. to be able to edit it again with all settings, Print and Cut Environments including the file used in the JobComposer, Ergosoft also offers the option of creating a so-called Job ...