Problem/Question When trying to run an application of Ergosoft kind of the following error message appears: “The application was unable to start correctly (0xc0000005)" Error Code 0xc0000005 could be caused by several reasons in a Windows PC like ...
Problem/Question When attempting to select an existing Cut Environment for a Summa Cutter or to start the CutQueue for a Summa, Ergosoft RIP displays an error message "Cut Driver not licensed" or "License count exceeded". The most common source of ...
Problem/Question The following messages may appear when starting a Network Department Client: If this message does not disappear in seconds/minutes, the Client can't connect to the Master. (A permanent network connection between all Networked ...
Problem/Question A job is aborted while rasterizing in RipServer with the following message "File could not be rasterized [111]" The typical source for this problem is that a Postscript file is either too large (Max. size postscript: 500,000 lines) ...