0x1203 Error: Command failed: S1 when measuring with Barbieri Spectro LFP

0x1203 Error: Command failed: S1 when measuring with Barbieri Spectro LFP

Problem/Question
When attempting to measure and/or do the White calibration with the Barbieri Spectro LFP, the measuring head does not move and it gives out the error message "0x1203 Error: Command failed: S1".

Solution/Work-Around

This issue usually appears when the device is set to transmission measurement, while the media being used is not suited for transmission measurement. Hence the device tries to measure through but can’t and therefore fails to measure. 

We would recommend to change the measurement model to the correct one for the respective media you are using and try it again, in most cases, this resolves the problem.

  1. Job Composer
  2. "Tools" menu
  3. "Application Defaults"
  4. "Spectrophotometer"
  5. <Options>

    • Related Articles

    • Restore Barbieri Spectro LFP

      Problem/Question "LFP is an OEM device and can´t be controlled" The Barbieri Spectro LFP is not recognized in Ergosoft and the Barbieri Gateway displays an error message stating that the Barbieri Spectro LFP is an OEM device and can´t be controlled. ...

    • Barbieri Spectrophotometer, Epson printer not available in the driver list

      Problem/Question When setting up a Barbieri Spectrophotometer or an Epson printer, the model is missing in the device list. The HTM drivers for Epson printers as well as the Barbieri Gateway software are large installation files. In order to keep the ...

    • Different density measurement results between V15 and V16

      Problem/Question When comparing density measurements between Ergosoft RIP 15 and Ergosoft 16, differences may occur. This is due to the newly added density specifications for the primary inks. Solution/Work-Around To change back to the default ...

    • COM Error 0x646 Fill Job failed

      Problem/Question When you cannot print from a hotfolder you will got the following error message in the hotfolder log “COM Error 0x646 Fill Job failed : Feature ID not registered" This error message only affects users with a Delta Automation license. ...

    • Summa license error (from 16.4)

      Problem/Question Using older Summa CutEnvironments containing S-Class or S2-Class driver with Ergosoft 16.4 or later can lead to error messages like "Contour Cut Driver not licensed. Please select a model on the General page. Continue anyway?" or ...